Service Mnaual
Table Of Contents
- Important Safety Information
- I. Construction and Refrigeration Circuit Diagram
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- IV. Refrigeration Circuit and Component Service Information
- V. Preparing the Appliance for Periods of Non-Use
- VI. Disposal
- VII. Technical Information
- A. Electrical and Refrigerant Data
- B. Wiring Diagrams
- 1a. Undercounter and Worktop: Refrigerator; Cabinet Thermostat
- 1b. Undercounter and Worktop: Refrigerator; Cabinet Thermistor/Control Module
- 2a. Prep Table; Cabinet Thermostat (Without Defrost Heater)
- 2b. Prep Table; Cabinet Thermostat (With Defrost Heater)
- 2c. Prep Table; Cabinet Thermistor/Control Module
- 3a. Undercounter and Work Top: Freezer; Cabinet Thermostat
- 3b. Undercounter and Work Top: Freezer; Cabinet Thermistor/Control Module
38
2) Remove the drawers. Pull the drawer out to its fully extended position. Open the safety
clips (one on each side) by sliding them forward, then rotating them up. See Fig. 16.
Lift up on the handle slightly, then pull to disengage the drawer. Be sure to support the
rear and front of the drawer while removing it. WARNING! Be sure to close the safety
clips when reinstalling the drawer.
3) Remove the 4 horizontal mullion screws, then cut the horizontal mullion silicone loose
and remove the horizontal mullion. See Fig. 17.
Upper Drawer
Lower Drawer
Drawer
Slides
Fig. 16
Safety Clips
Safety Clip
Closed
Safety Clip
Open
Fig. 17
Horizontal Mullion Screws
Horizontal Mullion
Silicone
Horizontal Mullion Silicone
Horizontal Mullion