Service Mnaual
Table Of Contents
- Important Safety Information
- I. Construction and Refrigeration Circuit Diagram
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- IV. Refrigeration Circuit and Component Service Information
- V. Preparing the Appliance for Periods of Non-Use
- VI. Disposal
- VII. Technical Information
- A. Electrical and Refrigerant Data
- B. Wiring Diagrams
- 1a. Undercounter and Worktop: Refrigerator; Cabinet Thermostat
- 1b. Undercounter and Worktop: Refrigerator; Cabinet Thermistor/Control Module
- 2a. Prep Table; Cabinet Thermostat (Without Defrost Heater)
- 2b. Prep Table; Cabinet Thermostat (With Defrost Heater)
- 2c. Prep Table; Cabinet Thermistor/Control Module
- 3a. Undercounter and Work Top: Freezer; Cabinet Thermostat
- 3b. Undercounter and Work Top: Freezer; Cabinet Thermistor/Control Module
43
18) Close the door and tighten the upper hinge bracket outer screw. See Fig. 28.
Upper Hinge Bracket
Outer Screw
Upper Hinge Bracket
Door Fully Closed
Fig. 28
19) Check the door operation to assure it opens and closes properly. Note: Hold door at
45°angle from closed position and release. Door should close on its own. If not, adjust
hinge bracket.
Drawer Relocation
Left Drawer Frame Relocation
20) Place the left rear bracket in place on the center rear drawer frame bracket with
hex-bolts removed in step4. Leave loose, do not tighten at this time. See Fig. 36.
21) Place the left front bracket in place on the vertical mullion bracket with the hex-bolts
removed in step 4. See Fig. 29. Leave loose, do not tighten at this time.
Center Rear
Drawer Frame
Bracket
Fig. 29
Vertical
Mullion
Hex-Bolts
Left Rear
Bracket
Left Front Bracket
Vertical Mullion
Bracket
Left Rear
Bracket
Center Rear
Drawer Frame
Bracket
Left Front Bracket
Vertical
Mullion
Vertical Mullion
Bracket