Service Mnaual
Table Of Contents
- Important Safety Information
- I. Construction and Refrigeration Circuit Diagram
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- IV. Refrigeration Circuit and Component Service Information
- V. Preparing the Appliance for Periods of Non-Use
- VI. Disposal
- VII. Technical Information
- A. Electrical and Refrigerant Data
- B. Wiring Diagrams
- 1a. Undercounter and Worktop: Refrigerator; Cabinet Thermostat
- 1b. Undercounter and Worktop: Refrigerator; Cabinet Thermistor/Control Module
- 2a. Prep Table; Cabinet Thermostat (Without Defrost Heater)
- 2b. Prep Table; Cabinet Thermostat (With Defrost Heater)
- 2c. Prep Table; Cabinet Thermistor/Control Module
- 3a. Undercounter and Work Top: Freezer; Cabinet Thermostat
- 3b. Undercounter and Work Top: Freezer; Cabinet Thermistor/Control Module
44
22) Place the left drawer frame in the appliance and align under the left rear bracket and
tighten, then align under the left front bracket and tighten. See Fig. 30.
Note: Be sure the left drawer frame is under both the left rear bracket lip and left front
bracket lip.
Left Drawer Frame
Fig. 30
Left Rear Bracket Lip
Left Front Bracket Lip
Right Drawer Frame Relocation
23) Place the right rear bracket in place on the right side panel with the hex-bolts removed
in step4. Leave loose, do not tighten at this time. See Fig. 31.
24) Place the right front bracket in place on the right side panel with the hex-bolts removed
in step4. Leave loose, do not tighten at this time. See Fig. 31.
Vertical
Mullion
Hex-Bolts
Right Rear
Bracket
Right Front Bracket
Right Rear
Bracket
Right Front Bracket
Vertical
Mullion
Fig. 31