FREEZER Instruction Manual ER1A-FS ER2A-FS EF1A-FS EF2A-FS Issued: 07-26-2019 Revised: 05-13-2020
WARNING Only qualified service technicians should install and service the appliance. To obtain the name and phone number of your local Certified Service Representative, visit www.economyseries.com. No installation or service should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/manager should not proceed to operate the appliance until the installer has instructed them on its proper operation.
TABLE OF CONTENTS Important Safety Information....................................................... 5 Know your Equipment.................................................................. 9 Check for Shipping Damage.......................................................... 10 Handling the Cabinet.................................................................... 10 Location........................................................................................ 11 Remove the Crate and Skid...............
ER1A-FS, EF1A-FS ER2A-FS, EF2A-FS 4
Important Safety Information Important Safety Information Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, damage to the appliance, or damage to property. Indicates a hazardous situation that, if not avoided, will result in death or serious injury. Indicates a hazardous situation that, if not avoided, could result WARNING in death or serious injury.
WARNING This appliance should be destined only to the use for which it has been expressly conceived. Any other use should be considered improper and therefore dangerous. The manufacturer cannot be held responsible for injury or damage resulting from improper, incorrect, and unreasonable use. Failure to install, operate, and maintain the appliance in accordance with this manual will adversely affect safety, performance, component life, and warranty coverage.
WARNING, continued • • • • • • • • • • • • • • • • • • This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be properly supervised around this appliance. Do not climb, stand, or hang on the appliance or door or allow children or animals to do so.
WARNING, continued • • • Do not store gasoline or other flammable liquids or gases, near this or other electrical equipment. Keep your fingers away from grills; the spaces between doors and cabinet are small, so be careful when closing doors when children are around. Unplug the cooler before cleaning or performing any repair. NOTICE • • • • Protect the floor when moving the appliance to prevent damage to the floor.
Know your Equipment DOOR CONTROL MODULE BACK GRILL SHELF CLIP SHELF POWER CORD CASTER CONDENSER 9
Check for Shipping Damage Prior to leaving the factory, each cabinet is throughly inspected and performance tested to assure proper operating temperatures. Check the crate thoroughly for signs of shipping damage. If external damage exists, internal damage is also probable. Uncrating should be done while the carrier´s representative is present. Otherwise, the equipment should be uncrated as soon as possible, preferably within five (5) days.
Location WARNING • This appliance is not intended for outdoor use. 1. Place the cabinet on a surface solid enough to prevent vibration and strong enough to support the combined weight of the cabinet and the product load. Quick guideline: Estimate 35 pounds per cubic foot of storage space. 2. Cabinets should never be placed in front of windows or glass doors where sunlight will be in direct contact with the units.
Remove the Crate and Skid 1. Remove the external packaging (corrugated board and plastic wrapping). Check for concealed damage. If any damage is identified, immediately forward a complaint to the transportation company. 2. Move the cooler to its final location, before removing the skid. 3. Using a screwdriver remove the screws that attaches the skid to the appliance. Screw Level the Cabinet To install casters: Casters are supplied with the equipment.
Electrical Installation Electrical Connection WARNING • • • • • • • Electrical connection must meet national, state, and local electrical code requirements. Failure to meet these code requirements could result in death, electric shock, serious injury, fire, or severe damage to equipment. This appliance requires an independent power supply of proper capacity. See the nameplate for electrical specifications.
Installing the Shelves Shelves and shelf clips (4 clips per shelf) are packed inside the cabinet prior to shipment. After selecting the appropriate spacing inside the cabinet, install shelf clips by inserting top of clip inside the pilaster and then press the lower section of the clip while pushing inwards until it snaps into place. Repeat until all clips are in desired location. Place shelf on clips checking that all four corners of shelves are leveled and supported by the four shelf clips.
Door Reversal APPLIES ONLY FOR SINGLE DOOR MODELS If you would like to reverse the door swing, follow the steps below. Otherwise, skip to section “Controls and adjustments”. TOOLS 3/8” NUT DRIVER BIT PHILLIPS # 2 SCREWDRIVER INSTRUCTIONS Step 1. Remove the four screws (two upper and two lower) from the header sign, then place it on top of the equipment.
Step 2. Remove the four screws from the front grill, then remove the front grill. Step 3. Remove the two screws from the lower hinge and remove the door by pulling straight down until it is free of the upper hinge pin.
Step 4. Remove the two screws from the upper hinge and place it on the opposite side of the equipment. Upper hinge Step 5. Remove the door bushing from the upper right corner and the lower hinge with the torsion mechanism and switch them, see the image below.
Step 6. After switching hinge and bushing position, turn the door 180°. Step 7. Change the door magnet from the top to the bottom of the door.
Step 8. Insert the door into the upper hinge and hold it while placing the lower hinge . Note: Turn the hinge in the opposite direction of the door opening, then fix it to the equipment with the two screws Step 9. Replace the lower left cap from the header sign to the upper right corner of the front grill and the upper left cap from the front grill to the lower right corner of the header sign. Step 9. Re-install the front grill and the header sign reversing the Steps 1 and 2.
Controls and Adjustments Your commercial Refrigerator or Freezer is manufactured with an electronic thermostat to control various functions of your unit, such as temperature, defrost cycles, alarms, etc.
HOW TO SEE THE SET POINT 1. The set point parameter is the temperature at which the compressor cuts out. 2. Push and immediately release the SET key: the display will show the set point value. 3. Push and immediately release the SET key or wait for 5 seconds to display the probe value again. HOW TO CHANGE THE SET POINT 1. Push the SET key for more than 5 seconds to change the SET point value. 2. The value of the set point will be displayed and the “C” or “F” LED starts blinking. 3.
Cleaning and Preventive Maintenance Your unit requires very little maintenance. However, periodic cleaning can help maintain efficiency and prolong product life. Remember to disconnect the power source before cleaning. Remove all products and place them in another cooler. 1. Clean once a month the condenser with a grease remover. The condenser is located in the lower part of your unit, behind the front grill. Condenser 2.
Disposal DANGER FLAMMABLE • • • The appliance contains refrigerant and must be disposed of in accordance with applicable national, state, and local codes and regulations. Refrigerant must be recovered by properly certified service personnel. The insulation foaming agent used for the unit body contains flammable gas cyclopentane. With this in mind, dispose of the product properly. Remove the door to reduce the risk of children getting trapped.
SERIES 618 Hwy. 74 South, Peachtree City, GA 30269 USA MAN-341-R (P) (800) 227-3172 www.economyseries.