Instruction Manual

3.2.1 Cleaning the Condenser Coil

Move the power switch to the “OFF” position, then unplug appliance, remove front

bottom panel and carefully slide out the condensing unit. The condenser coil requires

regular cleaning; recommended every 30-60 days, depending of the accumulation of

dust and grease. If the buildup on the coil consists of only light dust and debris the

condenser coil can be cleaned with a simple brush. Heavier dust build up may require a

vacuum or even compressed air to blow though the condenser coil. If heavy grease is

present there are de-greasing agents available for refrigeration use and specifically for

the condenser coils. The condenser coil may require a spray with the de-greasing agent

and then blown through with compressed air.

Be sure all electrical and mechanical parts are dry before turning on the power. Never

use a high pressure water wash for this cleaning procedure as water can damage the

electrical components located near or at the condenser coil. Do not place filter material

in front of condenser coil. This material blocks air-flow to the coil similar to having a dirty

coil!

If you keep the Condenser clean you will minimize your service expense and lower your

electrical costs. Failure to maintain a clean condenser coil can initially cause high

temperatures and excessive run times. Continuous operation with dirty or clogged

condenser coils can result in compressor failure.

To put back the condensing unit in its place, slide in the unit carefully. BE SURE DRAIN

PIPE IS LOCATED OVER THE PAN. Replace front bottom panel, plug the appliance

into the electrical outlet, then move the power switch to the "ON" position.

3.2.2 Draining the Unit

Each unit has a drain located inside the unit which removes the condensation from the

evaporator coil and evaporates it at an external condensate evaporator pan. The drain

can become loose or disconnected from moving or bumping the drain.

IF YOU NOTICE EXCESSIVE WATER ACCUMULATION ON THE INSIDE OF THE

UNIT be sure the drain tube is connected from the evaporator housing to the

condensate evaporator drain pan.

IF WATER IS COLLECTING UNDERNEATH THE UNIT you may want to check the condensate

evaporator drain tube to be sure it is still located inside the drain pan. The leveling of the

unit is important as the units are designed to drain properly when on a level surface, if

your floor is not level this can also cause drain problems. Be sure all drain lines are free

of obstructions; typically food product is found blocking drain lines causing water to back

up and overflow the drain pans.

The appliance also has drain tubing at the bottom of the unit for cleaning. Check that

this is not obstructed.