Instruction Manual

13
Defrost
Off-Cycle Defrost: the HDD-1-24 refrigerator defrost naturally between run cycles.
2.5 Tower Installation
This procedure describes how to install the towers and the air hose needed to provide
cold air directly into the towers.
Tools needed: Philips Screwdriver.
Step 1
Locate the gaskets and bolts included in with your Tower accessories kit. Place gasket
over the pre-drilled holes on top and place the 4 screws thru the tower base. Align the
tower with screws and gasket to the top as shown below while dropping the beer line(s)
thru the hole on top of the unit.
Step 2
Tighten the screws using the nuts found in your tower accessories kit
Step 3
Identify the “WHITE HOSE CORRUGATEDwhich is found inside of the equipment.
WHITE HOUSE
CORRUGATED