Owner's manual

11
B. Checks Before Installation
IMPORTANT
1. Install in accordance with all applicable national, state, and local regulations.
2. Remove the shipping carton, tape, and packing material. If any are left in the
icemaker or condensing unit, it will not work properly.
3. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
1. Icemaker
1) Remove the panels to prevent damage when installing the icemaker. (See "II.C. How to
Remove Panels.")
2) Remove the package containing the accessories.
3) Remove the protective plastic lm from the panels. If the icemaker is exposed to the
sun or to heat, remove the lm after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces.
5) This icemaker can be installed on dispenser units or storage bins 30" wide or wider. If
using a storage bin, the recommended storage bin is HOSHIZAKI ICE STORAGE BIN,
Model B-500 series. For more options, contact your local Hoshizaki distributor.
6) This icemaker is designed for connection to HOSHIZAKI CONDENSING UNIT,
Model SRK-14H or SRK-14H3 only!
NOTE: CONNECTION TO ANOTHER CONDENSING UNIT WILL VOID
WARRANTY.
2. Condensing Unit
1) See the nameplate on the condensing unit. Check that your voltage supplied
corresponds with the voltage specied on the nameplate.
WARNING
Electrical connections must be installed in accordance with applicable national,
state, and local regulations.
2) Remove the panels to prevent damage when installing the condensing unit (See "II.C.
How to Remove Panels.")
3) Remove the package containing the accessories from the condensing unit.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
5) Check that the compressor is snug on all mounting pads.