User's Manual

C. Control Buttons

The control board features RESET, SERVICE 1, and SERVICE 2 Buttons

1. RESET Button

• Press briey to go to initial harvest cycle.

• Press and hold for 3 seconds to enter control board setting mode. For details about

control board settings, see "III.D. Control Board Setting Mode and Control Board

Settings."

2. SERVICE 1 and SERVICE 2 Buttons

• Press the "SERVICE 1" or "SERVICE 2" button briey to display the current freeze

cycle termination temperature (Control Board Setting 2). This setting controls dimple

diameter. For details about adjusting the dimple diameter, see "III.H.1. Dimple

Diameter." NOTICE! Do not decrease dimple size below 3/16" (5 mm).

• Press and hold the "SERVICE 1" button for 3 seconds to enter information display and

model code setting mode. For details about information display and model code setting,

see "III.F. Model Code Setting Mode."