Instruction Manual

37
B. Startup
WARNING
• All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• To reduce the risk of electric shock, do not touch the plug with damp hands.
IMPORTANT
At startup, there is a slight delay before the compressor starts.
1) Plug the appliance into the electrical outlet. IMPORTANT! Perimeter heater, mullion
heater, and drain tube heater (drain tube heater on freezer models only), energize
once appliance is plugged into the electrical outlet and remain energized even
while the control module is in "OFF" mode. Appliance must be unplugged from
the electrical outlet to de-energize the heaters.
2) If the cabinet temperature is not displayed
on the control module, press and hold the
standby button on the control module until
"ON" appears in the display. See Fig. 71.
Factory default is "ON".
3) Allow the appliance to cool down prior to
loading it with food products.
Note: If the defrost thermistor is above
50°F (10°C), the evaporator fan motor is
de-energized until the defrost thermistor is
below 50°F (10°C).
C. Controls and Adjustments
1. Temperature Display
The cabinet temperature is displayed on the control module. See Fig. 72. The display
default is °F, but it can be changed to read °C. To change, see "II.C.3. Changing the
Temperature Display Scale (°F or °C)."
Control
Module
Front Panel
Fig. 71
ECO
°C
°F
V
V
Fig. 72
Up
Button
Down
Button
Front
Panel
Standby and Light
(glass door models)
Button
Manual
Defrost
Button
Control Module
Compressor Icon
Defrost
Icon
Evaporator Fan
Motor Icon
Alarm
Icon
Standby Button