Use and Care

15
7) Remove the ller cap, ller screws, and spring cartridge. See Fig. 12. Leave the
thrust-washers in place on the spring cartridge. NOTICE! Spring cartridge may be
difficult to remove. Be careful not to damage the nish.
Filler Cap
Door
Spring Cartridge
Filler Screws
Thrust-Washers
Screws
Fig. 12
8) Clear material from the spring cartridge hole to allow for spring cartridge installation.
Reinstall the ller cap, ller screws, and spring cartridge on the opposite side of the
door. See Fig. 13.
Filler Screws
Filler Cap
Door
Spring Cartridge
Screws
Fig. 13
9) Make sure the thrust-washers are in place on the spring cartridge, then install the upper
hinge bracket onto the spring cartridge. See Fig. 14. The upper hinge bracket should be
canted out towards the center as shown with the screw holes towards the back of the
appliance.
10) Remove the ller cap and nylon bearing from the bottom of the door. SeeFig.15.
Reinstall on the opposite side.
Upper Hinge Bracket
Door
Screw
Washer
Fig. 14
Fig. 15
Filler Cap
Nylon Bearing
Thrust-Washers
Screw Holes
Spring Cartridge Hole