Instructions Manual

40
6. Drawers
Drawers and drawer slides are removable.
• To remove a drawer: Remove all items from the drawer. Pull the drawer out to its fully
extended position. Open the safety clips (one on each side) by sliding them forward,
then rotating them up. See Fig. 44. Lift up on the handle slightly, then pull to disengage
the drawer. Be sure to support the rear and front of the drawer while removing it.
WARNING! Be sure to close the safety clips when reinstalling the drawer.
• To remove a drawer slide (center slide containing rollers): Push up on the stop
lever while pulling on the drawer slide. See Fig. 45. Drawer slides do not require
lubrication, but drawer slides should be kept clean and free of food.
Note: Drawer slides are dishwasher safe.
7. Worktop (Worktop Models)
Clean the work surface as often as necessary to maintain a clean, sanitary surface.
Clean any rust colored spots using a non-abrasive cleanser.
8. Cutting Board (Prep Table Models)
Remove and clean the cutting board as often as necessary to maintain a clean, sanitary
work surface. Also clean the space underneath the cutting board as often as necessary
to maintain a clean, sanitary surface. After cleaning, slide the cutting board back into the
cutting board brackets. WARNING! Make sure the cutting board brackets and cutting
board are secure. Otherwise, the cutting board could come off and cause injury.
Fig. 44
Safety Clips
Safety Clip
Closed
Stop Lever
Fig. 45
Safety Clip
Open
Stop Lever
Drawer Slide