Instruction Manual
Table Of Contents
- Important Safety Information
- I. Installation Instructions
- II. Operating Instructions
- III. Cleaning and Maintenance Instructions
- IV. Preparing the Appliance for Periods of Non-Use
- V. Disposal
11
Fig. 6
2. Check the Refrigeration Circuit
• Visually check that the refrigerant lines do not rub or touch other lines or surfaces and
that the condenser fan blade turns freely.
• Check that the compressor is securely attached.
3. Position the Appliance and Lock the Front Casters
The front casters on the appliance are lockable. After positioning the appliance in its nal
location, lock the front casters.
4. Install the Shelves
1) For each shelf, place the shelf support clips into the pilasters at the desired height
(4 shelf support clips per shelf). See Fig. 6.
2) Place the shelves in position on the support clips.
Shelf Support Clip
Pilaster
Shelf
Shim Plates
Caster
Fig. 5
4) Tighten the caster. See Fig. 5. NOTICE! Make sure the caster is tight and no slack is
left between the caster, shim plates, and appliance.
5) Repeat the procedure for other casters as needed.
6) Lower the appliance to the oor.
Caster Tight Against
Shim Plates and Unit