User's Manual

Page 2 of 5
User Manual/
ユーザーマニュアル
HRM1095MAN001
HRM1095
Ver.0.50 Approved
Product and Technology R&D Division
Hosiden Corporation
1 Product Overview/製品概要
Item
項目
Specification
仕様
Remark
備考
Model Name
製品名
HRM1095
PMN
：
Bluetooth Low Energy
Module
Frequency Range
周波数範囲
From 2402 MHz to 2480 MHz.
2402 MHz
以上
2480 MHz
以下
Operational Channel
作動チャンネル
2402 + 2n MHz (n = 0,1,2…39)
Data Rate
データレート
1 Mbps and 2 Mbps
1 Mbps
及び
2 Mbps
Intended End Usage
用途
Bluetooth
®
Low Energy Product
Bluetooth
®
Low Energy
製品
Installation Method
組み込み方法
Surface mount and reflow
表面実装及びリフロー
Operating Voltage
電圧範囲
From 1.7V to 3.6V, 3.0V typ
1.7V
以上
3.6V
以下
3.0V typ
Applicable FCC rules
適合 FCC 規則リスト
FCC Part 15 Subpart C
2 Legal Statement/
法的声明
2.1 FCC Compliance/FCC
適合
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
The regulatory label on the final system must include the statement: "Contains FCC ID:
VIYHRM1095" or using electronic labelling method as documented in KDB 784748.
The OEM integrators shall be responsible for testing and evaluation for any additional compliance
requirements required under regulations of each region with their finished product that is installed
this module. (for example:EMC, safety, etc)
The OEM integrators must select either DC / DC regulator or LDO regulator from the product's
internal power supply by the software.
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules)
listed on the grant, and the host product manufacturer is responsible for compliance to any other
FCC rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.
The manual for the final product with this product should state the following:
“This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.”
“This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has
very low levels of RF energy.”
The device is designed to use an integrated antenna. Do not modify the antenna or any other part
of the module. Any modifications will invalidate the modular certifications and require new approvals
for the host system.
In case a conflict arises between Japanese and English versions, English version takes priority.