User's Manual

ManualsBrandsHosiden ManualsElectronicsWireless Low Energy Module

User manual of HRM1017

Product: Wireless low energy module

Model: HRM1017

For OEM integration only – device cannot be sold to general public.

Therefore we will not supply the User’s manual, the installation manual is the official for OEM.

FCC ID: VIYRM1017

■Operational Information

This module has been tested and found to comply with the limits for a Class B digital device

pursuant to Part15 of FCC rules. This module complies with Part15 subpart C of the FCC

rules. Customers should check Part15 subpart B compliance with their own final products

and conduct certification if needed.

■Caution

Any changes or modifications are not expressly approved by Hosiden responsible for

compliance could void the user’s authority to operate the equipment.

■Requirement of Labeling

Please describe the following item on the final product including this module:

*If the device is too small to show the statement above, it can be placed on the user’s manual or on a container.

Contains Transmitter Module FCC ID: VIYRM1017

Contains FCC ID: VIYRM1017

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Summary of content (4 pages)

PAGE 1
User manual of HRM1017 Product: Wireless low energy module Model: HRM1017 For OEM integration only – device cannot be sold to general public. Therefore we will not supply the User’s manual, the installation manual is the official for OEM. FCC ID: VIYRM1017 ■Operational Information This module has been tested and found to comply with the limits for a Class B digital device pursuant to Part15 of FCC rules. This module complies with Part15 subpart C of the FCC rules.
PAGE 2
■Requirement of User’s Manual Statement “This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.” FCC NOTICE [Intended for Mobile equipment] This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE).
PAGE 3
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 4
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. 2) Module approval valid only when the module is installed by the OEM integrator. As long as 2 conditions above are met, further transmitter test will not be required.