User's Manual
Table Of Contents
- System Operating Manual ®
- Table of Contents
- Section 1 Descriptive Information
- Section 2 Principles of Operation
- Section 3 Equipment Description
- Section 4 Basic Operation
- Section 5 Select Mode
- 5.1 Modes of Delivery
- 5.2 PCA Only Mode
- 5.3 Continuous Mode
- 5.4 PCA+Continuous Mode
- 5.5 Protocols
- 5.6 Dose Limit
- 5.7 Clearing the History and/or Rx Settings
- 5.8 Using Review/Confirmation Screens
- 5.9 Changing Settings During Setup
- 5.10 Making Changes After Setup
- 5.11 Clearing Shift Totals
- 5.12 Changing a Vial
- 5.13 Adding a Supplemental Loading Dose
- 5.14 Checking History & Settings
- 5.15 History and Event Log
- Section 6 Advanced Programming with Hospira MedNetTM Software
- Section 7 Troubleshooting
- Section 8 Maintenance
- Section 9 Specifications
- Section 10 Prescription Delivery Limits
- Appendix A Generating Bar Code Labels (Hospira MedNetTM Software Enabled)
- Appendix B Network Printer Setup
- Appendix C Warranty
- Appendix D Contact Information
- Index
5 - 18 Select Mode
430-04685-001 (Rev. 7/05)
5.5 Protocols
For detailed startup information including vial insertion, clearing
settings, purging, and setting a Loading Dose,
see Loading a
Vial on page 4 - 20.
For information on adjusting system settings such as contrast
and volume
see Adjusting Settings on page 4 - 22.
NOTE: Protocols may be established by the hospital via
Hospira MedNet
TM
Software or via Biomed Mode. Hospira
MedNet
TM
Software enabled devices allow for protocol
programming from the Rx Rules application. Only
Protocols associated with the inserted drug vial will be
available.
1. Unlock door and press Button,
or load drug vial into cradle, to
power on the infuser. Upon initial
start-up, the self-test begins. It
may take several seconds for the
Hospira logo to appear on the
screen.
2. Select
CONTINUE> to advance to
the next programming screen.
3. Select
YES> or NO> at the NEW
P
ATIENT SCREEN if the infuser has been OFF 4 hours or less. For
more information see
New Patient on page 4 - 28.
4. Select
CONFIRM> to accept the inserted drug, or remove the
vial if it is not correct.
See New Patient on page 4-28 for more
information.
5. Select either
YES> or NO> to purge the system. For more
information see
Purging the System on page 4 - 29.
LIFECARE PCA
SELF TEST