Ice Maker Instruction Manual Model: IM01A
1. Important Safety Instructions Please read these instructions thoroughly before using this product and retain them for future use. WARNING: This appliance must be earthed. - - This Ice Maker is intended for household use only. If the power cord is damaged a replacement must be obtained from the manufacturer. Hold the plug firmly when removing it; do not pull the power cord. Do not place the appliance near an open flame, cooking or heating appliance, or hot surface. For indoor use only.
2. Operation a) Ice Making Cycle The ice making cycle has 5 steps: 1. Pumping water from the water tank up to the water tray. 2. Operating the refrigeration system to create the ice cubes. 3. Emptying the excess water from the water tray. 4. Releasing the ice cubes into the ice container. 5. Returning the water tray to its upright position. This cycle continues until the ice container is full of ice cubes or there is insufficient water in the water tank.
Ice Full Indicator (red): When the Ice Container is full of ice cubes, the indicator will turn red. The ice making cycle will stop after the next batch of ice cubes have been released into the container. The unit will then go into standby mode. Remove the ice cubes before pressing the 'STOP' and then 'START' buttons to restart the ice making cycle. Low Water Indicator (red): The Ice Maker will automatically check the water level in the Water Tank.
e) Electrical Connection Connect the supply cord to the socket at the rear of the Ice Maker. Insert the 3-pin plug into a 13A socket. Ensure that the supply is 220-240V 50Hz. Switch off the supply and remove the plug when cleaning the appliance or the appliance is not in use. (See picture below) WARNING: This appliance must be earthed. f) Drip Tray Position the Drip Tray provided under the front edge of the appliance.
h) Adding Water Slide the Ice Container fully forwards and then tilt it up slightly to remove it from the unit. Use the jug provided to pour potable water into the Water Tank. Note: Do not overfill the Water Tank above the ‘Full’ level. (See picture below). Return the Ice Container into its fully inserted position. FU L L FULL i) Draining the Unit The drain point is located underneath the unit, at the left hand side. Carefully position the unit over a sink/drain and unscrew the plastic cap.
3. Cleaning and Maintenance Note: Please clean the Ice Maker regularly. - Before cleaning the unit, switch off the power and remove the plug. Remove any ice cubes from the Ice Container and drain all the water from the Water Tank. - Use a dilute mild detergent in water to clean the inside and outside of the Ice Maker with a soft cloth. Rinse and dry thoroughly. Do not spray any liquids onto the appliance. - Do not use any acidic or abrasive detergents.
6. Trouble Shooting Problem The compressor makes a strange noise Possible Cause The sensor is broken Possible Solution Turn off the Ice Maker. Ensure the voltage is normal and restart. Remove the Ice Container. Wait several minutes before replacing the container and then restart the machine. Please clean the Ice Container and restart the unit. If the Ice Full Indicator fails to go off then the unit will need to be replaced.