F6 4-Channel Charger Instruction Manual

Charging
LiPo-6S(4.20V) 43%
00:00:01
CH1
0 mAh
22.83 V
0.0A 0W
3.802V
3.807V
1
4
3.808V
3.801V
2
5
3.801V
3.814V
3
6
Standby
00:00:00
CH2
10
F6 4-Channel DC Smart Charger
Charging
Operation
Time
Capacity
charged
Task Status
Output
Current
Total Battery
Voltage
Output
Power
Operation
Time
Cell Voltage
Current
channel
Current
channel
Battery parameters and
Percentage of completion
Operation and Setup
Working parameters Display
Charging Status : Simple Operation
1. Connect power supply to the charger, wait for the system to complete its self-checking.
Connect the battery to the charger in the standby interface;
2. After selecting the corresponding channel, short press the speed shuttle key to pop up
the "Task Settings" menu, set the task to "Charge" ; adjust the task parameters, and short
press the speed shuttle key to start the task;
Scroll the speed shuttle key can switch the display information in the lower half of the screen, which are cell voltage, cell
internal resistance and the operating data. Cell voltage can only be displayed in the mode of balance charging and the
internal resistance can only be displayed while measurement is valid ( not in precharged status and none of the cells
reaches fully charged status within 2 minutes);
3. When the charge task is executing, short press the speed shuttle key can pop up the "Adjust
Task” menu to adjust the charge current ; long press the CH key can stop the current task ;
4. Enjoy.