LARDER FRIDGE - MODELS RLA34,RLA36,RLM34,RLM36 INSTRUCTIONS FOR INSTALLATION & USE GETTING STARTED: STEP 2 STEP 4 Your fridge is now working. If after 24 hours your fridge is not operating as you want, refer to the Troubleshooting section. Read the rest of these instructions to get the best from your appliance and remember to fill in your guarantee registration. Keep this Book in a safe place for quick reference. SERVICE & GUARANTEE Plug in and switch on.
For Your Safety For your safety, read the following advice: The fridge cooling system contains a small amount of gas which is environmentally friendly but flammable. To avoid any risk :● SAFETY & INSTALLATION ● ● ● ● Install the fridge following the installation instructions and ensure that ventilation openings are kept clear of obstruction. Take care when installing or moving the fridge to avoid damaging the pipes on the rear.
Installation Location & Air Circulation 30mm (11/4 inch) Locate your fridge away from sources of heat e.g. cookers, radiators, direct sunlight as extreme temperature will affect its performance. Allow a minimum 30mm (11/4 inch) between the top of the fridge and the underside of the worktop. SAFETY & INSTALLATION Providing you follow the recommended ventilation requirements you will :● Prolong the life of the fridge. ● Minimise the risk of condensation on the outside of the fridge.
Installation Levelling: Level the fridge when it is in its final location by adjusting the front feet, until firm contact is made with the floor. This will stop rocking or vibration and keep the door aligned which helps the fridge run reliably and efficiently. SAFETY & INSTALLATION Before plugging in and switching on, leave the fridge standing in its final location for at least 15 minutes to allow it to settle.
Installation Electrical Supply WARNING: This appliance must be earthed. The fridge must be positioned so that the plug is accessible after installation. SAFETY & INSTALLATION Fuses Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only use those rated at 13A and ASTA approved to BS1362. Changing the Plug Cut off and dispose of the supplied plug if it does not fit your socket.
Controls Controlling the Temperature of the Fridge Compartment The control wheel on the front of the worktop adjusts the internal fridge compartment temperature. The internal temperature should be 5˚C or colder although some sections, such as the salad bin, will be slightly warmer. The setting of the control wheel will depend on the location of the fridge, the room temperature and how often the door is opened. The normal set point (marked by a 3 and N on the dial) is usually suitable.
Useful Advice A A B B C D B USEFUL ADVICE Note: The Rating Plate, which lists the appliance Model Number and Serial Number can be found near the bottom of the left hand internal wall. STORAGE ZONES Zone Type Food Storage A Cool Dairy products, Cheese, butter, margarine, Low fat spreads, cooking fats / lards Preserves - Jam, curd, marmalade, spread, salad dressing or sauces.
Useful Advice USEFUL ADVICE Making the best use of your Fridge Note : Always use the handle provided to open the fridge door. To ensure that your fridge operates as efficiently as possible : ● Follow food packaging “best before/use by” instructions or your suppliers advice on a suitable maximum storage time. ● Keep foods covered to retain moisture and prevent flavour/odour transference. Plastic bags, aluminium foil, plastic stretch wrap and containers with lids are ideal.
Useful Advice Advice on Adjusting Shelves Make the most of the interior storage space by repositioning shelves to suit the various heights of individual items you wish to store. To remove, ensure that the door is open fully. Slide the shelf forward and tilt from position. Split glass shelf The split shelf can be used as a standard shelf but also as two half shelves. The front half can be repositioned above or below to enable storage of larger items.
Defrosting and Cleaning No manual defrosting required The fridge compartment will defrost automatically. During defrost periods water droplets form on the interior back wall of your Larder Fridge and refreeze afterwards. Note : if your kitchen becomes exceptionally warm, your Larder Fridge may not defrost regularly. WARNING: Ensure the defrost drain hole is kept clear and that stored food does not come into contact with the interior back wall of your Larder Fridge.
Defrosting and Cleaning Going Away If you are going away and don’t want to use your fridge, switch off the socket outlet and pull out the mains plug. Remove food and follow the cleaning instructions on the previous page. Note : Leave the door ajar to prevent an accumulation of odours.
Maintenance You will need a selection of small hand tools, screwdrivers, spanners etc. to carry out this procedure. Our Service Department can arrange for an Engineer to do the conversion for you but a charge will be made. Door Reversal CLEANING & MAINTENANCE WARNING: Switch off electrical supply and pull out the mains plug. Remove loose items/fittings from inside the fridge and place food into insulated containers whilst carrying out this operation. 1. Open the door as wide as possible.
Troubleshooting IS THE FRIDGE WORKING AS YOU WANT? Have you read through the instruction book ? If you still have a problem, before calling our service organisation see if any of the tips below help. The interior light doesn’t work WARNING: Switch off the socket outlet and pull out the mains plug. 1. Check bulb is screwed in correctly. If still not working then see ‘Changing the Light Bulb’ in the CLEANING & MAINTENANCE section. The appliance will not work 1.
Hotpoint guarantee “Satisfaction guaranteed or your money back” We give you a unique ‘satisfaction guaranteed’ promise - valid for 90 days - after you have purchased your Hotpoint appliance. If there is a technical problem simply call Hotpoint Repair service or visit our web-site at www.hotpointservice.co.uk and where necessary, we will arrange for an engineer to call. If the technical problem is not resolved under this guarantee, we will replace your machine or, if you prefer, give you your money back.
After Sales Service “No company is better positioned to offer an after sales service on a Hotpoint appliance than us - the manufacturer” As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts and labour guarantee for the first 12 months. In addition to this you also have the advantage of free replacement parts for the first 5 years when fitted by a Hotpoint engineer.
Key Contacts After Sales Service Over 1100 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we offer. Repair Service and Information Help Desk UK: 08709 066 066 Monday to Friday, 8am to 7.30pm Saturday, 8.30am to 5.30pm Sunday, 9.30am to 3.30pm www.hotpointservice.co.