User Manual

DESIGN INSPIRAT I O N
Software Notice
Usage Notice
1. If you find the Binary Editor doesn’t respond when you first launch the Binary Editor software, it may be because the Binary
Editor is initializing (loading presets, user data, IR files, etc.). Please wait for a few seconds and try again.
2. Please launch the Binary Editor first before connecting your Binary pedal to your computer. If your device cannot be recognized,
reconnect the power jack and try again.
Firmware Update Notice
To perform a manual update if your Binary pedal crashed:
1. Press and hold the footswitch along with the “-” and “GLOBAL” buttons, then power Binary on.
2. Connect a USB cable to your computer and open the Binary software.
3. Select the firmware update option and follow the procedure for the newest update.
4. After the update is complete, select and run “Restore Factory Settings” from the software.
5. When complete, disconnect the cable and operate your Binary as normal.
Warning: Breaking the USB connection during the firmware update process may result in an operation crash.
Note: Please close your anti-virus software or disable disk scan function before using Binary Editor with Binary IR Cab, since it may
cause Binary Editor crash.