User Manual

www.hotoneaudio.com
Bluetooth MIDI Controller
Screen Display Getting Started
The Bluetooth indicator (the dot shown
above) will flash when Ampero Control
is in Bluetooth Pair Mode (hold FS 2+3).
1. Turn on the Bluetooth switch on your mobile device,
then turn on your Ampero Control and launch the app.
2. Login your account (optional).
3. Press and hold FS 2+3 on your Ampero Control to
enable Bluetooth Pair Mode. A dot will flash on the
bottom right corner on the screen of your unit to
indicate pairing status on.
4. When your Ampero Control appears listed on the
startup page, select and tap the “Connect To The
Selected Device” button on the screen. If search failed,
you can retry searching by manually tap “Search
Again” button.
PC CC
PC CC
ThisindicatesaPC
message(PC16)
hasbeensent
ThisindicatesaCC
message(CC112)
hasbeensent
MIDI
PC CC PC CC
PC CC PC CC
Bluetoothnot
connected
Bluetooth
connected
Bluetooth
PC CC PC CC
Thisindicatesunitbank
change
(bank00tobank01)
Bank
Notes:
1. You can enter offline mode if no device is found.
2. Ampero Control can only be edited by one device at a
time. To use other devices, tap “Settings” icon on the
lower right corner of the screen, find “Connection
Status” and enter, then tap “Disconnect”. Connect
another device when finished.
3. The default device name is Ampero Control. You can
customize your device name if needed.
4. If search failed (no device found or timeout), you can
retry searching by manually tap “Search Again” button,
or restart Bluetooth on your mobile device.
5. When using Bluetooth connection for editing or MIDI
control, please keep your Ampero Control close to your
phones/pads/computers for best possible experience.
The recommended range is less than 5m.