User Manual
Table Of Contents
- Cover
- Contents
- Welcome
- Notice
- Definitions
- Panel
- Getting Started
- Main Display Screen
- Using the Interface
- Tools
- Customizing Your Ampero II Stomp
- EDIT
- Effects Chains Menu
- Input Node Setup
- Output Node Setup
- Effects Chain Types
- Using Effects Chain Templates
- Split/Mixer Node Settings
- Save Effects Chain Templates
- Module/Effect Menu
- Suggested Setups
- Effect List
- Troubleshooting
- Technical Specifications
Nodes
The beginning/end of an effects chain or the intersection of two effects chains is called a “node”:
• Input node is the beginning of an effects chain that sets signal input source
• Output node is the end of an effects chain that determine where the signal outputs to
• Split node separates one effects chain into two and sends separated signals in a certain way that determined by node
settings, appears on chain A only
• Mixer node mixes two effects chains into one and outputs in a certain way that determined by node settings, appears on
chain A only
A1
A2
A3
A4
A5
A6
B1 B2
B3
B4
B5 B6
Chain A
Chain B
Chain A
Chain B
Chain A
Chain B
Effects Chain Basics
The upper effects chain is called effects chain A (or simply “chain A”), the lower chain is called effects chain B (or simply “chain B”):
The signal flow direction is fixed from left to right:
InputNode
SplitNode
OutputNode
MixerNode
Notice that the upper chain is always chain A, the lower is always chain B, regardless of chain type
Effect Slots
Effect slots (or simply “slots”) are spaces located on an effects chain for adding effects. Ampero II Stomp features 6 slots on one
effects chain, 12 slots in total. Slot numbering is shown below:
Customizing Your Ampero II Stomp
Number indicates signal flow – 1 is the first and 6 is the last
12
DES I GN IN S PIRATION