User Manual

CTRL Target
Use the CTRL Target menu to select which slots of the current patch will be controlled by the CTRL footswitch.
Function/Module
Color
DRV, DYN
Red (LED on=slot on, LED off=slot off, same below)
WAH, VOL
Cyan
AMP, PRE AMP
Blue
EQ, FREQ
White
CAB, IR
Yellow
MOD, FX LOOP, FX SND, FX RTN
Green
DLY, RVB
Purple
CTRL
Red/Green
Tap Tempo
Flashing Blue
EXP On/Off
Red (Off)/Green (On)
Slot A1 and A2 are loaded with DYN and WAH modules and
controlled by CTRL footswitch
Slot A3 is loaded with DRV module and not controlled by CTRL
footswitch
B2 – NONE indicate slot B2 is empty slot
Use the quick access knobs to change between yes/no, and press the arrows on the right/left to scroll through the modules.
Function, module and footswitch color are listed below:
The 12 effects slots are listed in the panel, with yes and no below each module to show if the CTRL footswitch is activated or not:
Quick Access Para
This menu allows you to set the three quick access of current
patch available in main menu. The targets can be all effects
parameters used in the current patch, patch volume and patch
tempo.
Use SLOT/FUNC to select a target slot/function. The available
selections depend on the modules/effects used in the current
patch. If there is no module/effect, the available selections are
OFF, Patch Tempo, Patch Volume only.
If you don’t want the quick access knob on, select OFF to turn its function off. When a quick access knob is off, the parameter
panel will display the status as shown:
If you select a slot, SLOT FX will show the current effect you’re using in the center of the panel.
Use PARA to select the parameter you want to control. The controllable parameters will vary with different effects. Please refer
to Effects List (on ) for more info. page 41
Customizing Your Ampero II Stomp
25
DES I GN IN S PIRATION