User Manual

Customizing Your Ampero II Stomp
Use OUTPUT SOURCE and FX SND SOURCE to select from different output signal source for output and FX loop send jacks:
•Normal: Both effect and USB audio output will be sent to the corresponding jack.
•USB Only: Only USB audio output will be sent to the corresponding jack. When Ampero II Stomp is your main USB audio
interface, if you need to monitor a track in a DAW while recording (or software monitoring), this selection is recommended. If
not, you’ll hear both unit effect output and a slightly delayed DAW monitor output.
•Dry: Both dry signal and USB audio output will be sent to the corresponding jack.
USB Audio
Use this menu to set up USB audio settings when using Ampero II Stomp as a USB audio interface.
Ampero II Stomp features a 8-in, 8-out USB audio interface with signal routings shown as below:
USB Audio Inputs Routing
Same rule as above: even number stands for left channel and odd number stands for right channel.
•Chain A outputs (after slot A6) are sent to USB Audio Input 1/2
•Chain B outputs (after slot B6) are sent to USB Audio Input 3/4; USB Audio Input 3/4 remains as long as the chain B is
activated (not shown grey; regardless of chain B output node settings)
•When chain A and B are in series, USB Audio Input 1/2 and 3/4 are the same
•FX Loop Return inputs are directly sent to USB Audio Input 5/6 regardless of patch settings
•Input L/R signals (dry signal) are directly sent to USB Audio Input 7/8 regardless of patch settings
USB Audio Outputs Routing
•USB Audio Output 1/2 (the main output) are sent to output L/R and phones jacks
•USB Audio Output 3/4 to 7/8 are reserved for sending different USB outputs depending on your settings of your computer or
DAWs
When recording, adjust the optimal REC LEVEL for each USB Audio Input 1/2 to 7/8 according to the instrument or other input
you’re using. Adjustable ranges are all from Mute~-60dB~+20dB, defaults are all set to 0dB.
Use MONITOR LEVEL to set a proper monitor level for overall USB audio outputs. Adjustable range is from Mute~-60dB~+6dB,
defaults is set to 0dB.
Use OUTPUT SOURCE and FX SND SOURCE to determine which USB audio output will be sent to the corresponding jack. In
default, the OUTPUT SOURCE is set to USB OUT 1/2, and FX SND SOURCE is set to USB OUT OFF.
Please note:
(1) When using FX Loop Send jack as a output jack, the output signal may vary from patch settings, such FX SND/FX LOOP
module parameter settings and position on effects chains, output node settings, etc.
(2) OUTPUT SOURCE option also affects phones output.
31
DES I GN IN S PIRATION
REC LEVEL(1/2) REC LEVEL(3/4) REC LEVEL(5/6)
0dB
>
FXSNDSOURCE
USBOUTOFF
<
0dB 0dB
REC LEVEL(7/8) MONITORLEVEL OUTPUTSOURCE
0dB
>
0dB USBOUT1/2
<