User Manual
Table Of Contents
- Cover
- Contents
- Welcome
- Notice
- Definitions
- Panel
- Getting Started
- Main Display Screen
- Using the Interface
- Tools
- Customizing Your Ampero II Stomp
- EDIT
- Effects Chains Menu
- Input Node Setup
- Output Node Setup
- Effects Chain Types
- Using Effects Chain Templates
- Split/Mixer Node Settings
- Save Effects Chain Templates
- Module/Effect Menu
- Suggested Setups
- Effect List
- Troubleshooting
- Technical Specifications
Global EQ
This menu allows you to setup Ampero II Stomp’s global EQ for overall tone sculpting:
This is a 4-band parametric EQ with low/high cut and low/high shelf filters with individual band on/off switches:
•LOW CUT: High pass filter that attenuates low frequency contents under the frequency you set; available parameters are
FREQ and Q
•LOW SHELF: Low shelf filter that boosts/cuts low frequency contents under the frequency you set; available parameters are
FREQ, Q and GAIN
•BAND 1-4: Peak filters that boosts/cuts a certain frequency range; available parameters are FREQ, Q and GAIN
•HIGH SHELF: High shelf filter that boosts/cuts high frequency contents above the frequency you set; available parameters are
FREQ, Q and GAIN
•HIGH CUT: Low pass filter that attenuates high frequency contents above the frequency you set; available parameters are
FREQ and Q
Detailed parameter descriptions:
•FREQ: Controls the filter center frequency/cutoff frequency ranging from 20Hz to 20000Hz. The default frequency of each
bands are:
LOW CUT and LOW SHELF: 20Hz
BAND 1: 100Hz
BAND 2: 500Hz
BAND 3: 1600Hz
BAND 4: 5000Hz
HIGH CUT and HIGH SHELF: 20000Hz
•Q: Controls the filter Q (width/sharpness or smoothness for low/high cut filters) from 0.1 to 10. Defaults are all 0.71.
•GAIN: Controls filter gain from -12dB to +12dB. Defaults are all 0dB.
•Volume: Sets the global EQ output from 0 to 100. Default is 50.
Customizing Your Ampero II Stomp
BacktoGLOBALmenu
Current global EQ curve
showing how global EQ affects
your tone
Global EQ output
Turn global EQ on/off
Restore all global EQ parameters
Current band name and type
Band switcher
On/off switch of current band
Availlable parameters of current band
Please note:
•Please carefully set global EQ parameters for protecting your devices and ears
•USB Audio will NOT affected by global EQ
•If a band doesn’t work, please check whether the band is on or not
•Reset button will reset ALL global EQ parameters
•If you’re using patches/effects (like reverbs) need a lot of DSP power, in this case, turning on global EQ may cause system
overload
35
DES I GN IN S PIRATION