User Manual

Mode 1: The default display mode which stresses patch number:
Display
This menu setup display modes and system UI language.
Use DISPLAY MODE to switch between two display modes:
Customizing Your Ampero II Stomp
After pressing Factory Reset, this display will come up with a warning.
Pressing YES will perform the factory reset. Pressing NO will return to the
previous menu.
After continuing with the factory preset, this screen will appear showing
that reset is in progress. Do not disconnect the power supply while the
reset is in progress. Disconnecting the power supply may cause Ampero II
Stomp to malfunction.
When the factory reset is complete, this message will appear. Press OK to
return to the main menu.
Use LANGUAGE to switch system UI language.
Use COLOR to choose from 7 system UI colors.
DISPLAY TIME lets you set how long screen display lasts for energy saving. Selections are Always On, 1min, 5min, 10min,
20min, 30min, 40min, 50min, 60min. Default is 30min. When screen display goes out, any operation (e.g. touch the screen, plug
in cables, press any footswitch) will wake up the screen.
About
About will show you information about Ampero II Stomp’s firmware and hardware.
Mode 2: Stresses patch name:
Use this menu to perform a factory reset. Remember, resetting Ampero II Stomp will delete all of your saved changes
and personal settings. Once it is executed, it cannot be undone, so please back up your settings before performing a
factory reset.
Factory Reset
36
DES I GN IN S PIRATION
FirmwareVersion：V1.0.0
HardwareVersion：V1.0.0
©Hotone Audio co., Ltd. All rights reserved.