User Manual
Table Of Contents
- Cover
- Contents
- Welcome
- Notice
- Definitions
- Panel
- Getting Started
- Main Display Screen
- Using the Interface
- Tools
- Customizing Your Ampero II Stomp
- EDIT
- Effects Chains Menu
- Input Node Setup
- Output Node Setup
- Effects Chain Types
- Using Effects Chain Templates
- Split/Mixer Node Settings
- Save Effects Chain Templates
- Module/Effect Menu
- Suggested Setups
- Effect List
- Troubleshooting
- Technical Specifications
Connecting pedalboards
Set your Ampero II Stomp into your pedalboard, then connect other pedals/controller depending on I/O configurations. When
Ampero II Stomp is used as your core gear, if you’re using FX loop jacks, please make sure FX loop related modules/nodes are
properly set.
Please adjust patch volume properly or volume drop will occur when bypassing/engaging your Ampero II Stomp like a pedal.
Please remember bypass mode (DSP/Analog) may alter the tone a lot (e.g. connected in front of a fuzz pedal). If tonal issue
(which may caused by impedance mismatch) occurs, try to switch to a different bypass mode.
Suggested Setups
38
DES I GN IN S PIRATION