Operation Manual

ARISTON DISHWASHER - Instructions for installation and use 15
D
ISHWASHER
You have loaded your dishes and you now have
to set the wash cycle. It takes just one minute
to learn how
Starting the dishwasher
Make sure the
wash cycle has
ended before
removing the
dishes!
If opening the door
soon after the end
of the
programme,or
during it, stand
away from the
Dishwasher, to
avoid possible
injury from hot
steam.
You've left out a dish?
Well, it happens to everyone.
Interrupt the wash cycle by
pressing the ON-OFF button, insert
the dish you had forgotten and
press the ON-OFF button again.
The cycle will start up from where
you interrupted it.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity comes
back on or when you close the door.
Everything is under control!
You can modify
the wash cycle in
progress, if it
has only just
started.
Ready, steady, go!
First of all.
After performing all the operations
described in the previous
paragraphs, turn the water tap on
completely and press ON-OFF
button "A", and the indicator light
"B" lights up. Now the appliance is
on and ready to be programmed.
Selecting the wash
cycle.
To select the wash cycle, turn knob
"D" clockwise until the reference
notch on the knob corresponds with
the number or symbol for the cycle
you wish to set (have a look at the
wash cycle table on page 17).
The indicator light "E" relative to
the cycle start phase will go on.
The dishwasher keeps
you informed.
Your dishwasher is fitted with
indicator lights (E) which light up
to indicate the cycle phase under
way.
Here are the symbols correspond-
ing to each cycle phase:
pre-wash, wash, rinses, drying.
At all times, your dishwasher tells
you which cycle phase is under
way.
Modifying a wash cycle
in progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Turn the knob
anti-clockwise until it reaches the
Reset position and, after a few
seconds, the indicator light "E" will
turn off. This is to inform you that
all the settings have been can-
celled. You are now free to re-set
the correct wash cycle.
Finished?
The end of the wash cycle is
indicated by the flashing of the
drying phase indicator light.
Turn off the water tap.
Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry
better thanks to the steam.
Empty the lower rack first.
Warning:
Turn the knob anti-clockwise to
Reset in order to reset all the
settings. Turn the appliance off
by pressing button A, unplug the
appliance from the electricity
socket to cut off the power supply;
the power supply cable should
consequently be easily
accessible.