Setup and user guide

ManualsBrandsHotpoint ManualsDomestic AppliancesBI WDHG 75148 EU

Quick Guide

THANK YOU FOR PURCHASING A HOTPOINT PRODUCT.

To receive more comprehensive assistance, register the

appliance on

www.hotpoint.eu/register

Before using the appliance carefully read the Health and Safety guide.

Before using the machine, it is imperative that the transport bolts are removed. For more

detailed instructions on how to remove them, see the Installation Guide.

CONTROL PANEL

WASH CYCLE TABLE

For all testing institutes:

2) Long cotton cycle: set programme 5 at temperature 40°C.

3) Long synthetics cycle: set cycle 6 at a temperature of 40°C.

* By selecting the cycle and excluding the spin cycle, the washer-dryer will drain only.

** If a drying cycle is also programmed, the machine will run a “wash+dry” programme lasting

45’ and a 1kg laundry load.

The cycle duration indicated on the display or instruction manual is an estimate based on

standard conditions. The actual duration may vary in relation to several factors, such as

the temperature and pressure of the incoming water, ambient temperature, amount of

detergent, load quantity and type, load balancing and any additional options selected.

1) Test programme in compliance with standard EN 50229 (Wash):

This cycle is designed for normally soiled cotton loads and is the most ecient in terms of

both electricity and water consumption; it should be used for garments washable at 60°C.The

actual washing temperature may dier from the indicated value.

Test programme in compliance with standard EN 50229 (Drying): select the 10 wash

programme and set the drying level to “ ”, for both loads. The rst drying cycle must be

carried out with the nominal load.

Maximum load 7 kg

Power input in o mode 0.5 W / in left-on mode 8 W

Detergents and

Additives

Recommended

detergent

Wash cycle

Temperature

Maximum

spin

(r.p.m.)

Max.

load

(kg)

Duration

(Minutes)

Drying

Wash

Fabric

softener

Powder Liquid

Default Range

2 3

1 Daily Mix Wash & Dry 40 °C

- 40 °C 800 3,5

The duration of the wash cycles can be checked on the display.

  

–



2 Shirts & T-Shirts 40 °C

- 40 °C 1000 2

  

–



3 Pre Iron – – – 1,5 – – – – –

4 Steam Refresh – – – 1,5 – – – – –

5 Cotton (2) 40 °C

- 60 °C 1400 7,0

    

6 Synthetics (3) 40 °C

- 60 °C 1200 4

    

7 Anti Stain Quick 40 °C

- 40 °C 1200 3,5

  

–



8 Anti Stain 100 40 °C

- 40 °C 1400 7

  

–



9 White 60 °C

- 90 °C 1400 7,0

    

Eco Cotton (1)

60 °C

- 60 °C 1400 7,0

    

11 Coloureds 40 °C

- 40 °C 1400 7,0

  

–



12 Ultradelicates 30 °C

- 30 °C 0 1

  

–



13 Wool 40 °C

- 40 °C 800 1,5

  

–



14 Fast 30 min ** 30 °C

- 30 °C 800 3

  

–



Rinse + Spin – – 1400 7,0



–



– –

Spin + Drain * – – 1400 7,0



– – – –



Required dosage  Optional dosage

1. ON/OFF button

2. START/PAUSE button

3. TEMPERATURE button

4. ENERGY SAVER button

5. DRY ONLY button / Lock

button

6. DRYING SETTINGS button

7. START DELAY button

8. SPIN SPEED button

9. WASH CYCLE SELECTOR KNOB

1 2

DISPLAY INDICATORS

Washing phase

Indicates washing phase of the cycle

Drying phase

Energy Saver activated

Key lock activated

Drying only

Time drying mode

Drying automatic levels

Start delay activated

Door locked

PRODUCT DESCRIPTION

1. Worktop

2. Detergent dispenser

3. Control panel

4. Door handle

5. Door

6. Water lter

7. Adjustable feet (4)

DETERGENT DISPENSER

Compartment 1:

Do not insert detergent in this compartment.

Compartment 2: Washing detergent

(powder or liquid)

Compartment 3: Additives (fabric softeners,

etc.)

The fabric softener must not exceed the “MAX”

level.

! Use powder detergent for white cotton

garments, for pre-washing, and for washing at

temperatures over 60°C.

! Follow the instructions given on the detergent packaging.

Summary of content (4 pages)

PAGE 1
Quick Guide EN THANK YOU FOR PURCHASING A HOTPOINT PRODUCT. To receive more comprehensive assistance, register the appliance on www.hotpoint.eu/register Before using the appliance carefully read the Health and Safety guide. Before using the machine, it is imperative that the transport bolts are removed. For more detailed instructions on how to remove them, see the Installation Guide. CONTROL PANEL 1 1. ON/OFF button 2. START/PAUSE button 3. TEMPERATURE button 4. ENERGY SAVER button 5.
PAGE 2
WASH CYCLES Follow the instructions on the symbols of the garment’s wash care label. The value indicated in the symbol is the maximum recommended temperature for washing the garment. Daily Mix Wash & Dry use programme 1 to wash and dry mixed garments (cotton and synthetics). This cycle may be used to wash and dry loads of up to 3,5 kg; we recommend the use of liquid detergent. The use of the steam in this programme is optimised to reduce the formation of creases on garments, making them easier to iron.
PAGE 3
Setting the drying cycle The first time the button “ ” is pressed, the machine will automatically select the maximum drying cycle which is compatible with the selected wash cycle. Subsequent presses will decrease the drying level and then the drying time, until the cycle is excluded completely (“OFF”). Drying may be set as follows: A- Based on the desired laundry dryness level: Cupboard : suitable for laundry which can be put back in a cupboard without being ironed.
PAGE 4
TROUBLESHOOTING Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Service, make sure that the problem cannot be easily solved using the following list. Anomalies Possible causes / Solution The washer-dryer does not start. The appliance is not plugged into the socket fully, or not enough to make contact. There is no power in the house. The washer-dryer door is not closed properly. The ON/OFF button has not been pressed. The wash cycle does not start.