Instructions for Installation and Use Washing machine Model BS 1400
Instructions for use WASHING MACHINE Contents GB English,1 GB Installation, 2-3-4-5 Unpacking and levelling, 2 Electric and water connections, 2-3 The first wash cycle, 4 Technical details, 5 Washing machine description, 6-7 Control panel, 6 Display, 7 Starting and Programmes, 8 Briefly: how to start a programme, 8 Programme table, 8 Personalisations, 9 BS 1400 Setting the spin cycle, 9 Setting the temperature, 9 Setting the Delay Start, 9 Functions, 9 Detergents and laundry, 10 Detergent dispense
Installation GB ! Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washing machine to inform the new owner as to its operation and features. ! Read these instructions carefully: they contain vital information on installation, use and safety.
Connecting the drain hose the socket is earthed and in compliance with the applicable law; the socket is compatible with the washing machine's plug. If this is not the case, replace the socket or the plug. 3 Service As the colours of the wires in the lead may not correspond with the coloured markings identifyng the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or coloured Green or Green & Yellow.
GB If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt the electrical supply to your machine, consult a qualified electrician before use.
Technical details 68,6 cm wide 100 cm high 72,5 cm deep Capacity from 1 to 8,5 kg Electric connections voltage 230/240 Volts 50 Hz maximum absorbed power 2500 W Water connections maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.5 bar) drum capacity 80 litres Spin speed up to 1400 rpm Control programmes according to IEC456 directive programme C; temperature 60°C; run with a load of 8,5 kg.
Washing machine description Control panel GB ON/OFF FUNCTION button buttons Display START/CANCEL SPIN TEMPERATURE DELAY START button Control knob KEYBOARD LOCK Programme key: to consult a straightforward chart of the different programmes available turn the lower part outwards to open it. DELAY START button to delay the start of the set programme for a maximum period of 24 hours (see page 9). KEYBOARD LOCK key. To lock all the keys on the washing machine during operation or during Standby mode.
Display GB In addition to being a practical tool to programme your appliance (see page 9), the display provides useful information concerning the wash cycle and status. Cycle phase under way: Description The following information is displayed during the wash cycle: Installation Once you have pressed the START/CANCEL button to start the programme, the display will indicate the amount of time left until the end of the wash cycle.
Starting and Programmes Briefly: starting a programme GB displayed. The temperature and spin speed are automatically set according to the programme (to change them, see page 9). 5. Select any function (see page 9). 6. Start he programme by pressing the START/ CANCEL button. To cancel it, keep the START/CANCEL button pressed for at least 2 seconds. 7. When the programme has ended, the word END is displayed. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. 8.
Personalisations Setting the spin cycle Setting the Delay Start Keyboard Lock (see page 7). Detergents Press the button and you will see the word OFF on the display, while the relative symbol flashes. Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the remains on.
Detergents and laundry GB Detergent dispenser Preparing your laundry Good washing results also depend on the correct dose of detergent: adding too much detergent won't necessarily make for a more efficient wash, and may in fact cause build up on the interior of your appliance and even pollute the environment. Divide your laundry according to: - the type of fabric/the symbol on the label. - the colours: separate coloured garments from whites. Empty all pockets and check for loose buttons.
Precautions and advice General safety obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. This washing machine should only be used by adults and in accordance with the instructions provided in this manual.
Care and maintenance GB Cutting off the water or electricity supply Turn off the water tap after every wash. This will limit the wear of your appliance's water system and also prevent leaks. Unplug your appliance when cleaning it and during all maintenance operations. Cleaning your appliance The exterior and rubber parts of your appliance can be cleaned with a soft cloth soaked in lukewarm soapy water. Do not use solvents or abrasives.
Troubleshooting Your washing machine could fail to work. Before calling for Assistance (see pages 17-18), make sure the problem can't easily be solved by consulting the following list. GB The water inlet hose is not connected to the tap. The hose is bent. The water tap is not turned on. There is a water shortage. The water pressure is insufficient. The START/CANCEL button has not been pressed. The washing machine continuously loads and unloads water.
GB 14
GB 15
GB 16
Guarantee Your appliance has the benefit of our manufacturers guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.
After Sales Service No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1100 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08709 066 066 Republic of Ireland: 0818 313 413 www.hotpointservice.co.
