Install Instructions

Care and Cleaning

CLEANING THE DOORS

Take particular care not to damage the inner

surface of the door inner glass that is coated with

a heat reflective layer. Do not use scouring pads,

or abrasive powder, which will scratch the glass.

Ensure that the glass panel is not subjected to

any sharp mechanical blows.

Stubborn stains can be removed by using a fine

steel wool soap pad. For slight soiling the inner

glass panel may be cleaned, while still warm,

without removing it from the door. After cleaning,

rinse and dry with a soft cloth.

DROP DOWN DOORS

Remove the door inner glass as follows.

Remove screws from both side of door

Gently ease the top trim away from door

Gently ease glass upwards and remove from door

NEVER OPERATE THE COOKER WITHOUT THE

INNER DOOR GLASS IN POSITION.

Refit the door inner glass as follows.

1. Open the door fully.

2. Locate the inner door glass into its slots.

3. Carefully slide the glass into its slots as far as it

will go and replace the top filler cap as well as the

tapping plates

4. Ensure the tapping plates are correctly fitted, as

theycan easily fall out and get mislaid.

* Only available on certain models.

Catalitic Cleaning

In some models, the most exposed internal vertical

sides of the oven are coated with porous enamel,

which is called catalytic enamel. When heated, this

enamel destroys fat particles given off by the food.

This „oxidation” of the fat particles occurs when the

temperature of the sides exceeds 170°C. The porous

quality of the catalytic enamel increases the surface

area where the exchange vital to the oxidation of the

fats takes place.

If there is still grime on the catalytic surfaces after

the cooking programme has ended, leave the empty

oven on with the door shut, turning the temperature

adjustment knob to its maximum setting. Leave the

oven like this for a period of time between 60 and 90

minutes, according to how much dirt was left inside.

The cleaning process for more stubborn food residues

may be quickened by using hot water and a soft brush.