EN Operating Instructions
11 2 4 3 5 1 6 7 8 9 10 II E75 AA0 UK | II DC60 AA0 UK 10 II C50 AA0 UK
A B C D
E F G H 5 I J 5
en General safety INSTRUCTIONS • • • • • • • • • • If the plug, power cord or appliance appear to be damaged or if any visible damage or water leaks are found, do not operate the iron. In such cases have it checked by Hotpoint’s authorised staff in order to avoid any hazardous situation. If the appliance was dropped, do not operate it.
Description of the appliance • 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. • Shot-of-steam button Steam button Power cable holder Filler hole lid Maximum filling level Water reservoir Cable winder Temperature indicator light Soleplate Temperature control (if available) Pure Water filter • • • • Introduction • This appliance was developed for household use only and is not intended for industrial use.
en Removing the plug If your appliance has a non-rewireable moulded plug and you should wish to re-route the mains cable through partitions, units etc., please ensure that either: • or: • the plug is replaced by a fused 13 ampere rewireable plug bearing the BSI mark of approval. the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.
en 1. 2. Place the Compact Generator in a horizontal position, open the lid of the filler hole (4) and fill the water reservoir using the water measurer supplied with the iron (6). Close the lid of the filling hole. Fabrics with this symbol on the label must not be ironed. garment label Never add any perfume, vinegar, starch, scale-removing agents, ironing products or other chemicals in the water reservoir - unless recommended by Hotpoint. Never use contaminated water. synthetic 2.
en Ironing with shot of steam (F) Cleaning the iron (I) The shot-of-steam function allows you to eliminate persistent creases. You can use this function both in no-steam and steam ironing mode. 1. Make sure that the water level in the reservoir is higher than 1/4. 2. Select the recommended ironing temperature using the temperature control (10) - see step B, chapter “Using the Compact Generator” and paragraph “Selecting the temperature”. 3.
en • We recommend using a cotton cloth to prevent any shiny marks on the garment. Never iron areas with obvious perspiration marks because the heat will fix the stains and make them permanent.
en Troubleshooting Problem The soleplate stays cold and does not warm up. Possible causes / Solutions • • The plug may not be inserted into the electrical socket or it may not make contact. Make sure that the temperature is not set to MIN. The temperature indicator light goes on and off. • The temperature indicator light is on. This shows that the Compact Generator is warming up. The indicator light will go off when the set temperature is reached.
www.indesitcompany.com Compact Generator UK 02/2014 ver.3.