Spec Sheet

HDF310PGR
Hotpoint
®
Built-In Dishwasher
For answers to your Hotpoint product questions, visit our website at
hotpoint.com or call 800.626.2000. Specification Revised 11/20
Listed by
Underwriters
Laboratories
DIMENSIONS AND INSTALLATION INFORMATION
ELECTRICAL RATING
Voltage AC.................................................120
Hertz...........................................................60
Total connected load amperage................6.6
Calrod
®
heater watts................................800/500
For use on adequately wired 120-volt,
15-amp circuit having 2-wire service
with a separate ground wire. This appliance
must be grounded for safe operation.
NOTE: Dishwasher must not be installed more than 10 feet
from sink for proper drainage. All plumbing and electrical work
must be in accordance with local codes. Dishwasher includes
drain hose and leveling legs.
INSTALLATION INFORMATION: Before installing, consult
installation instructions packed with product for current
dimensional data.
This Wall Area
must be Free
of Pipes or
wires
33-1/2" to 34-3/4"
Underside of
Countertop
to Floor
Figure A
Cabinets
Square
and
Plumb
24"
Min.
4"
6"
Plumbing and Electric Service
Must Enter Inside This Area
24"
Min.
24"
Typical
33-3/8" MIN.
adj to
34-5/8" MAX.
23-3/4"
29-7/8"
27-1/2"
4" (toekick)

Summary of content (2 pages)