Installation & Assembly

11
Installation Instructions
ALIGNING THE MOUNTING PLATE
Wear gloves to avoid cutting
fingers on sharp edges.
Draw a vertical line on the wall at the center of the 30s
wide space.
Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or
the level line drawn in Step C for cabinets with
front overhang. Line up the notch and center line
on the mounting plate to the center line on the
wall.
While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C, and D (see
illustration above/actual plate marked with arrows) .
Four holes must be used for mounting.
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud. It is
important to use
at least one wood screw mounted firmly in a stud
to support the weight of the microwave oven.
Set the mounting plate aside.
Risk of electric shock. Can cause
injury or death. Take care to not drill into electrical
wiring inside walls or cabinets.
Drill holes on the circles. If there is a stud, drill a
3
»16s
hole for wood screws. For holes that don’t line up with
a stud, drill a
5
»8s hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
2
3
4
Draw a
Vertical Line
on Wall from
Center of
Top Cabinet
Area E
Hole A
Hole B
Hole D
Notch
Hole C
D
1
30”
WARNING
CAUTION