Installation guide

Installation Instructions

OUTSIDE TOP EXHAUST (Vertical Duct)

INSTALLATION OVERVIEW

A1. Atlach Moundng Plate to Wall

A2. Prepare "Ibp Cabinet

A3. Check Damper Operation

A4. Mount Microwave Oven

AS. Adiost Exhaust Adaptor

A6. Connect Ductwork

I-_ ATTACH THE MOUNTING

PLATE TO THE WALL

Atlach the plate m the wall using toggle bolts.

At least one wood screw l](ll_lStbe used to attach

tile plate to a wall stud.

[] Remove tile loggle wings ti'Olll tile bohs.

[] Insert the bolts into tile moundng plate

through tile holes designated to go into drywall

and reattach tile loggle wings to :_A"onlo each bolt.

To use toggle bolts:

Spacingfor Toggles

MoreThanWall

_l_Ttlickness

IToggleWings

Mounting IIII I /Toqqle II I'1

PIate,dlLl_ II Ik

111:[2 ,, ,,

Bolt[nd

[] Place the mounting plate against the wall and

insert tile loggle wings into the holes in the wall

to II_lo/lnt tile plate.

NOTE: Before tightening toggle bolts and wood

s(rew, inake sllre tile tabs oil tile inolln[iIlg pla_e

louch tile bottom of the cabinet when pushed

flush a_ainst tile wall and that tile plate is properly

centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers

between the back of die mounting plate and the wall.

_ Tighten all bolts. Pull tile plate away from the wall

to help tighten tile bohs.