Installation guide

Installation Instructions
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes ff_r the top support screws, a
hole large enough for ltle power cord to fil lhrough,
and a cutout large enough for the exhaust adaptor.
• Read tim instructions Oil tile TOP CABINET
TEMPLATE.
• "Pape it underneath die lop cabinet.
• Drill the holes, fbllowing the instructions Oil tile
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in tile cabinet bottom.
CHECK FOR PROPER
DAMPER OPERATION
Newer Hate
Exhaust Adaptor
{absentonmodelsshipped
for rec#culationexhaust)
• Place the microwave in ils upright posilion, with tile
top of tile unit facing up.
• This microwave oven may be shipped assembled for
top exhaust (adaptor installed) or for recircolalion
exhaust (adaptor absent).
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• You will need m make adjnstments lo assure proper
alignInent with your house exhaust duct after the
Inicrowave is installed.
I-_ MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFE'IN, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, ose tile nylon
grommet aroond the power cord hole to prevent
cutting of the cord.
NOTE: We recommend nsing filler blocks if the
cabinet front hangs below the cabinet bottom shell
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
NOTE: When mounting
tile microwave ()veil,
thread power cord
through hole in bottom of
mp cabinet. Keep it fight
throughout Stops 1-3. Do
not pinch cord or lift
oven by pulling cord.
_Lifl tilt it
Inicrowave,
forward, and hook
slots at hack bottom
edge onto four lower
labs of inouIlliIlg
/ \
_ Rotate ]_i'Ollt of oven \\\
\
up against cabinet \_5._
bottom.
[] Insert a self:aligning screw through top center
cabinet hole. Temporarily secure tile oven by
turning tile screw at least two full turns afler tile
threads have engaged. (It will be complelely
lightened lalen) Be sure to keep power cord
tight. Be careful not m pinch the cord, especially
when mounting flush to bottom of cabinet.
13