Installation guide

Installation Instructions
[-_ ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
[] Place tile blower/lni! back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
]Secure blower unit to microwave with tile screw
removed in Step 4.
[]Replace blower plate with tile screw reInoved iIl
Step 1.
I-_ MOUNT THE MICROWAVE
OVEN
FOR *EASIER INSTALLATION AND PERSONAL
SAFElY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
groInmet around tile power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if tile
cabinet front hangs below the cabinet bottom shelfi
IMPORTANT: If filler blocks are not used,
case damage may occm" from overtightening
screws.
NOTE: When moonfing
the II(licrowave oveIl_
thread power cord
through hole in botloIn of
top cabinet. Keep it fight
throughout Slaps 1-3. Do
not pinch cord or lift
oven by pulling cord.
_Lif] microwave, flit it
ff_rward, and hook
slots at back bottom
edge onto four lower
labs of Inounfing
/
_ Rolale tront of oven \\\\
up against cabinet _
bottom.
[] Insert a self_aligning screw through top center
cabinet hole. Telnporarily secure tile oven by
turning/lie screw at least two full turns after the
threads have engaged. (It will be completely
fighwned later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
CabinetFront
_ CabinetBottomShelf
Vl / / FillerBlock
I/!1/'; ! _1!1 EquivabnttoDepth
',, " (/ I _ of CabinetRecess
MicrowaveOvenTop
_Attach tile microwave oven to tile top cabinet.
21