Installation guide

Installation Instructions

PLACEMENT OF THE MOUNTING PLATE

[-_ REMOVING THE MICROWAVE

OVEN FROM THE CARTON/

REMOVING THE MOUNTING

PLATE

[] Remove the inslMlafion instructions, filters, glass

tray and tile small hardware bag. Do not remove

the S|yrofimm prolecting the front of tile oven.

[]Fold hack all 4 carton flaps fiflly against carton

sides. Then carefhlly roll tile oven and carlon over

onto the lop side. Tile oven should be resting in

the Slyrofbam.

Styrofoam,

_Pull the carton up mid off the oveIl.

[] ReInove mid properly discard plastic bags.

Mounting

Plate

[Remove lhe 2 screws fi'oIll lhe mounting plale.

This plate will be used as dm rear wall template

and for mounting. You may discard these screws.

I-_ FINDING THE WALL STUDS

[] Find the studs, using one of the fbllowing

methods:

A. Stud finder - a Inagnetic dm4ce which

locates nails.

B. Use a hamIner to lap lightly across the

moundng surface lo find a solid sound.

This will indicate a stud location.

[After locating the stud(s), find the cenler by

probing dm wall widl a small nail to find the edges

of dm stud. Then place a mark half,ray bet_veen

the edges. The center of any adjacent studs should

be 16" or 24" fl'om this mark.

[]Draw a line down Ihe center of the studs.

THE MICROWAVE MUST BE CONNECTED TO

AT LEAST ONE WALL STUD.