Installation guide

Installation Instructions

ADAPTING MICROWAVE

BLOWER FOR RECIRCULATION

_ RelllO_e tile back top center blower illOtoF (]ooI"

retaining screw.

Blower Motor-- Back of

Microwave

Blower Door

Screw

_Open the blower door b) lifting it up at the back

side of the microwaxe, Remo'_e and saxe the top

and back retaining screws that hold the blower

IllOtoI" in the illiCi'Owa_e,

Retaining

screw

Retaining

screw

_ Carefiflly slide the blower motor toward the right,

and lift it partially out of the opening. Note: The

blower wires are long enough to allow flexible

handling while perfimning these steps, Discmmect

the wires OlflV if it is necessary fl)i" additional

flexibility,

Backof

Microwave

_ Remo_e the two screws holding the o-ra_ colored

inlet sleeve to the blower unit, Rotate the gra)

slee'_e as shown tmtil the _ora_, arrow lines up with

the "R", Recirculating exhaust. Reinstall the two

scYews.

Remove screws from

Gray Inlet Sleeve XxJ_

_Roll the assembled blower trait so that the

black-colored exhaust outlet faces the fl'ont of

the microwave and the gra)_colored inlet sleeve

taces downward,

o " ' ( ( _ ,

NOTE: The gra_-c _1_red sleeve o )ening must

AI)'_YS tace downward to ensure proper

operation of the i/lici'owa_e,

Must Face

Black

Exhaust

Outlet Facing

the Front

Backof

Microwave