User's Manual
Table Of Contents
- T10F
- English
- 1 Safety instructions
- 2 Markings used
- 3 Torque flange versions
- 4 Application
- 5 Structure and mode of operation
- 6 Mechanical installation
- 7 Electrical connection
- 8 Calibration
- 9 Settings
- 10 Loading capacity
- 11 Maintenance
- 12 Dimensions
- 13 Order numbers, accessories
- 14 Specifications
- 15 Supplementary technical information
- English
Electrical connection
T10F A0608-14.0 HBM: public 43
Possible faults and their elimination:
Fault: No signal at the output, amplifier indicates overflow.
Cause: Too little power, T10F disconnects.
Remedy: Switch position 3.
Fault: The calibration signal has been triggered by mistake.
Remedy: Switch position 1.
7.4 Option 2, code SF1/SU2
On the stator housing, there are two 7‐pin device
connectors (Binder 723) and in the case of the speed
module option, there is also an 8‐pin device connector,
assigned in accordance with the selected option.
The supply voltage and the calibration signal of
connectors 1 and 3 are direct‐coupled via multifuses
(automatically resetting fuses).
Assignment for connector 1
Voltage supply and frequency output signal.