User's Manual
Table Of Contents
- 1 Safety instructions
- 2 Markings used
- 3 Application
- 4 Structure and mode of operation
- 5 Mechanical installation
- 6 Electrical connection
- 7 Shunt signal
- 8 Functionality testing
- 9 Loading capacity
- 10 Maintenance
- 11 Waste disposal and environmental protection
- 12 Dimensions
- 13 Order numbers, accessories
- 14 Specifications
- 15 Supplementary technical information
18
Transducer without speed measuring system
Transducer with speed measuring system
Sensor head for measuring speed
Stator housing
Antenna wire
Lower antenna segment
Fig. 5.11: Stator housing and lower antenna segment with antenna wire
1. Undo and remove the bolted connections (M5) on the upper antenna segment.
There are fan type lock washers between the antenna segments: Make sure that they do
not get lost.
2. Use an appropriate base plate to install the stator housing in the shaft train so that there
is sufficient opportunity for horizontal and vertical adjustments. Do not fully tighten the
bolts yet.
3. Now use two hexagon socket screws to mount the upper antenna segment removed
in Point 1 on the lower antenna segment.
Make sure that the two fan type lock washers are inserted between the antenna
segments (these ensure that there is a defined contact resistance)!
Important
To make sure that they function perfectly, the fan-type lock washers (A5, 3-FST DIN 6798
ZN/galvanized) must be replaced after the bolted antenna connection has been loosened
three times.
Version b 13.01.2015 HBM: public