User's Manual

Order numbers, Accessories
T40FM A3276-8.0 HBM: public 87
Nominal (rated) torque M
nom
807060504030252015kNVm
Permissible axial displacement
between rotor and stator (without ro
tational speed measuring system)
18)
mm
" 2
Weight
Rotor without speed measuring
system
kg 18 28 39
Rotor with rotational speed
measuring system
kg 20 32 42
Stator kg 1.8 2.1 3.0
1)
Output signal range in which there is a repeatable correlation between torque and output signal.
2)
Output signal range in which there is a repeatable correlation between torque and output signal.
3)
Signal frequency range 0.1 to 10kHz.
4)
At nominal (rated) conditions.
5)
The pulse tolerance improves with reduced distance and vice versa.
6)
The data refers only to a central axial alignment. Deviations lead to a change in pulse tolerance.
7)
Note the necessary termination resistances as per RS-422.
8)
Heat conductance via the stator base plate necessary over 70°C. The temperature of the base
plate must not exceed 85°C.
9)
At nominal (rated) conditions.
10)
The data refers only to a central axial alignment. Deviations lead to a change in pulse tolerance.
11)
Each type of irregular stress (bending moment, lateral or longitudinal force, exceeding nominal
(rated) torque) can only be permitted up to its specified limit, provided none of the others can
occur at the same time. If this condition is not met, the limit values must be reduced. If 30% of
the limit bending moment and lateral limit force occur at the same time, only 40% of the
longitudinal limit force is permissible and the nominal (rated) torque must not be exceeded. The
effects of permissible bending moments, longitudinal and lateral forces on the measurement
result are ≤±1% of the nominal (rated) torque. The load limits only apply for the nominal (rated)
temperature range. At temperatures <10°C, the load limits must be reduced by approx. 30%
(strength reduction).
12)
The data refer to static loading of the measuring body; note the bolted connection!
13)
The nominal (rated) torque must not be exceeded.
14)
FCC compliance on request
15)
Option 7, Code S
16)
The antenna ring and connector plug must be fixed.
17)
The influence of radial run-out deviations, eccentricity, defects of form, notches, marks, local
residual magnetism, structural inhomogeneity or material anomalies needs to be taken into
account and isolated from the actual undulation.
18)
Above the nominal (rated) temperature range ±1.5 mm.