Owner's manual

C – Ver. 9.02 – June 2011
7
Entering and changing data in steps
By pressing STEP when PROGRAMME is active, the step display is turned on and shows ”1”.
The data of the first step can now be entered.
To move on to the next step (1-3) and read and change settings, press STEP again.
Choose and change temperature, time, core temperature, exhaust and fan as in manual
operation.
Stop between steps: To turn the alarm between steps on and off, press ALARM. If the control
lamp is on, the programme ends with the current step and a beep is heard. The oven does not
proceed to the next step until the oven door is opened and closed or you press ALARM.
To store a change made in the step mode, press PRG for 2 seconds.
Leave STEP by choosing another programme with the turn switch.
Be careful not to use the turn switch when a value flashes. If you turn the switch while you are
working in STEPS, the computer switches to the next programme and all changes are lost.
Delete current step by pressing STEP and ALARM simultaneously for 2 seconds.
When the programme has started, you can still change time, temperature, core temperature
and the settings of fan and exhaust. These changes will then only be active in the current run.
Note that the display shows the total time remaining after start and that it will show the time
remaining in the current step when you press TIME.