Instruction Manual

IMPORTANT

The following installation instructions must be followed for warranty purposes and for optimal performance. Hourwall does not

install panels or have control over the installation of the panels, therefore these Installation Instructions are to be used as

guidelines. Hourwall

CLASSICBRICK panels are for inside (interior) use only.

It is the responsibility of the installer to ensure all Hourwall products are installed in accordance with the CLASSICBRICK

Installation Instructions. InStone assumes no liability for improper installation or personal injury resulting from proper or

improper use or installation.

SAFETY FIRST

The operator of any power tools or other tools should be skilled and familiar with the correct use of each tool.

Proper safety gear must always be worn.

BUILDING CODE

Follow local Building Codes when applying Hourwall. It is the responsibility of the installer to ensure that applicable building

codes are met or exceeded.

PRODUCT COLORING:

Please ensure, wherever possible, that the production dates on all product being installed side-by-side are the same or

compatible. This will help ensure consistent coloring. Most of the time product from different dates will match up, but the

installer should check this before installing. Also, there is the possibility for a panel to be slightly off colored in a batch. Again, the

installer should check all panels match before installing.

For more information, please visit our website or contact us:

www.hourwall.com * Toll Free at 1-877-477-4373 * Email at info@instoneproducts.ca

CLASSIC

BRICK

½” Installation

RECOMMENDED TOOLS:

Miter Saw and/or Table Saw Drill Measuring Tape

Pencil Level 10 oz. Caulking Gun

Metal Square / Ruler Drywall Saw Utility Knife

Safety Glasses Earplugs Dust Mask

PAGE 1
R CLASSICBRICK ½” Installation IMPORTANT The following installation instructions must be followed for warranty purposes and for optimal performance. Hourwall does not install panels or have control over the installation of the panels, therefore these Installation Instructions are to be used as guidelines. Hourwall CLASSICBRICK panels are for inside (interior) use only.
PAGE 2
R CLASSICBRICK ½” Installation 1. MEASURE and MARK: Products should be measured and marked on the ‘brick-finish’ surface (face) of each panel. Using a measuring tape, mark with a pencil, and then use a straight edge to mark a cutting line. 2. CUT: The panels are easiest cut with the backside down. Use a hand saw or miter saw to make the cut. For cutting panels lengthwise, a table saw is recommended.
PAGE 3
R CLASSICBRICK ½” Installation OUTSIDE CORNERS BUTT JOINT CORNER MITERED JOINT CORNER BUTT JOINT CORNER - the panels can simply be butt together to create a finished corner. If any cut edges are exposed, the appropriate coordinating Hourwall Paint Kit should be used to color the ends. MITERED JOINT CORNER (recommended) - the panels can be mitered to create a more finished/continuous look. Cut the panel at a 45-degree angle, then use the same piece to continue the return.