Installation Instructions

Fig. 3
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holes all your parts. Check that all parts are
included as shown in the illustrations and the Parts List.
2. Shut off power at the circuit breaker and completely
remove the old fixture from wall, including the old mounting
strap.
3. Mounting Strap(A) contains several pairs of threaded
holes. Find the pair of holes that match the spacing of the
holes in Back Plate (K). Thread the Mounting Screws(B) half
way into Mounting Strap(A).
4. Place Mounting Strap (A) over the Junction Box (E) so the
Mounting Screws (B) are vertical or horizontal, as required by
fixture type.
5. Attach Mounting Strap (A) to the Junction Box (E) by using
Mounting Screws(D). Tighten the screws securely.
Fig. 1
CONNECTING THE WIRES (Fig. 2)
6. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE ( or RIBBED) .
7. Ground wire connection: Connect the fixture ground wire
to house ground wire, which usually has green or copper
insulation, with the correct size of wire connector. If there is
no house ground wire at ceiling junction box then attach
fixture ground wire securely onto green grounding screw
located on the mounting bar.
NOTE: Twist the wires together in the same direction that you
twisted the wire connector onto the wires.
8. Tuck the wire connections neatly into the Junction Box.
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
FINISHING THE INSTALLATION (Fig.3)
9. Place Back Plate (J), over Mounting Screws(B), so that the
screws protrude through the holes in Back Plate (J).
10. Thread Deco Nuts (H) onto Mounting Screws (B) and
continue turning until the Back Plate (J) is snug against the
wall.
11. Carefully press the clips inside of the shade (K) onto the
bulb.
YOUR INSTALLATION IS NOW COMPLETE. RETURN POWER
TO THE JUNCTION BOX AND TEST THE FIXTURE.
BARE COPPER
(Ground)
GREEN
(Ground)
FIXTURE WIRES
SMOOTH (BLACK)
RIBBED (WHITE)
BLACK
WHITE
HOUSE WIRES