User's Manual

- [GREEN] 3.5mm Auxiliary Input: This input will be triggered automatically
when a 3.5mm auxiliary cable (included) is plugged into One Foundation.
- USB-A Port: 2.1A Charging Port
Easy To Use
[ILLUSTRATION OF ROTARY DIAL – Ill. 8]
One Foundation uses one convenient control dial to operate power, volume, and
input selection.
- Press the control dial once to turn One Foundation on
- Press the control dial again while One Foundation is on to cycle through
active inputs
- Turn the control dial to adjust volume
- Press and hold the rotary dial to turn One Foundation off
Remote
[ILLUSTRATION OF REMOTE – Ill. 2]
- Input: Cycle through connected inputs or press and hold to engage Bluetooth
Pairing Mode.
- Power: On/Off
- FF: Press for next track, press and hold for fast forward
- RW: Press for previous track, press and hold for rewind
- Play/Pause: Play/Pause track
Connecting Your Device via Bluetooth®
Pairing Mode (Blinking Blue LED)
One Foundation automatically goes into Bluetooth Reconnect Mode for 10 seconds
as soon as you turn it on (fast flashing BLUE led). It then switches to Pairing Mode
(slow flashing BLUE led). You can pair a new device to One Foundation when in
Pairing Mode.
Note: Holding the [INPUT BUTTON] on the One Foundation remote for 3 seconds
will disconnect the device currently connected and go into Pairing Mode. Pairing
mode can also be engaged by disconnecting a connected device or by pressing the
[BT PAIR] on the back of One Foundation.
Connected Mode (Solid Blue LED)
Use your Bluetooth-enabled device to pair to One Foundation. One Foundation does
not require a pairing password. Once paired, the LED will glow solid blue.
Note: One Foundation will automatically pair with the last device connected to it
when turned ON (when the device is available).
Connecting other devices
The various inputs on the back of One Foundation allow you to connect other
devices to the system.