Installation Guide

23800-5-0909 Page 13
Plastering (Figure 19)


into wall space.
Use wood strips nailed to inside of studs and top of bottom plate.
These must be removed before installation of furnace. Lath and
plaster against top projection of Header Plate.

Figure 19
Installing Furnace
1. Clear the recess of all debris, and remove any wood plaster-
grounds.
 
 

4. Swing bottom of furnace into wall opening with back of legs

 
FINISHING INSTRUCTIONS
Figure 20
IMPORTANT — Avoid securing too tightly and disturbing the
inner casing. Do not try to force furnace into a wall opening which

OUTER CASING
1. Align 1 3/4" slot on casing bracket with bottom screw hole on

10 x 1/2" screws for each casing bracket. Do not completely
tighten screws at this time.
CASING BRACKET
Figure 21
HEADER ASSEMBLY
66 1/4”
(1683mm)
WALL
OPENING