Installation Guide
23800-5-0909Page 6
Introduction
Vented wall furnace is shipped ready to install in a 2" x 4" stud wall,
Building Department regarding regulations, codes or ordinances
which apply to the installation of a vented wall furnace.
Instructions to Installer
1. Installer must leave instruction manual with owner after instal-
lation.
-
plied with furnace.
3. Installer should show owner how to start and operate furnace
and thermostat.
Warning:
Any change to this furnace or its control can be dangerous.
This is a heating appliance and any panel, door or guard
removed for servicing an appliance must be replaced prior
to operating the appliance.
General Information
Standard / CSA Standard Z21.86 and CSA 2.32 by the Canadian
Standards Association, as a Vented Wall Furnace and must be
installed according to these instructions.
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not shown
on the rating plate is the responsibility of the person and com-
pany making the change.
Important
All correspondence should refer to complete Model No., Serial
No. and type of gas.
Notice:
out and smoke will occur. To prevent triggering of smoke alarms,
ventilate the room in which the furnace is installed.
Installation in Residential Garages
so that all burners and burner ignition devices are located not less
to physical damage by a moving vehicle.
person or through a representative is engaged in and is responsible
jurisdiction.
State of Massachusetts: The installation must be made by
Massachusetts.
The installation must conform to local codes or, in the absence of
local codes, with the National Fuel Gas Code ANSI Z223.1/NFPA
54* Natural Gas and Propane Installation Code, CSA B149.1.
*Available from the American National Standards Institute, Inc., 11 West 42nd St.,
New York, N.Y. 10036.
High Altitudes
feet above sea level. Canadian High Altitudes for locations having
INTRODUCTION
SPECIFICATIONS
Model
HW250GW Series HW350GW Series
Width
Gas Inlet Pipe 1/2" 1/2"
Vent Pipe Type B Oval
Accessories
HWGWTB2 HWGWTB2
HWGWTR HWGWTR
HWGWTW2 HWGWTW2
Attention: When the HWGWTW2-1, Out-of-the-Wall kit is used the HWGWTR-1, Rear Register kit cannot be used.