Installation Guide
23800-5-0909 Page 7
Note:
4" Oval (all parts purchase locally)
1. Type B-1 oval pipe
pair of ceiling plate spacers.
Type B-W gas vent pipe is available for single story or
multi-story installations. Type B-W gas vent pipe is to
be used with the Listed base plate, ceiling plate spacers
RECOMMENDED VENT CONFIGURATION
Figure 3
Figure 4
Insulated Vent Enclosure
poor venting. The cold vent pipe will have a delay in proper venting and
cause the wall furnace to shut "off" by the vent safety switch. To prevent
enclosure is recommended.
to combustibles.
Use metal thimble to protect vent pipe as it passes through combustibles.
Baseplate Gasket is factory installed on header. Baseplate attaches to header
with screws. B-vent snaps into and is attached to baseplate. Minimum
Stud space around gas vents must be free of obstructions and building
paper.
Uninsulated Single-Wall Metal Pipe shall not be used outdoors in cold
Attention: The main burner uses room air for combustion. As the gas/air
lint particles into the main burner.
Dust and lint accumulation inside the main burner will result in a yellow
and vent pipe. To clean main burner refer to Page 13, "Proper Main Burner
Flame."