Installation Guide

Installing the Blower
1. Install furnace according to Installation Instructions and Owner's
Manual.
2. Refer to Figure 1 for measurements to locate two (2) mounting
holes on wall surface above furnace
Figure 1
On Solid Wall
3. After locating mounting holes, attach two (2) #10 X 1 1/2"
screws provided in blower kit into wall. Do not completely
tighten screwheads to wall, leave a 7/16" gap between screw-
heads and wall.
Figure 2
On Sheet Rock Wall (Drywall)
3. After locating mounting holes, drill two (2) 5/16" diameter
holes into wall. Insert the two (2) plastic expansion anchors
provided in blower kit into holes. Insert two (2) #10 x 1 1/2"
screws provided in blower kit into plastic expansion anchors.
Do not completely tighten screwhead to plastic expansion
anchors, leave a 7/16" gap between screwheads and plastic
expansion anchors. Refer to Figure 3.
Figure 3
Figure 4
4. At the top of outer casing remove one (1) screw from center
clearance slot that attaches outer casing to header assembly.
Also, remove two (2) screws that attach bottom of outer casing
to inner casing. See Figures 5 and 6.
Figure 5
23820-3-0409Page 2