Installation Guide

Figure 6
5. Remove the outer casing and place aside.
6. Remove (4) 8 x 3/8" screws that attach blower front to blower
housing. Separate blower front from blower housing. Remove
blower front by disconnecting fan control switch wire assembly
from power cord and motor wire.
Figure7
7. Position blower housing on top of header assembly. Align
key hole slots on back of blower housing with the two (2)
screws attached to wall. Do not tighten housing mounting
screws
Figure 8.
8. Route three-prong cord set between left side of outer casing
and innner casing. Replace the outer casing and attach to
header assembly. Attention: The center clearance hole will
not be used. The two outside clearance holes will be used to
attach outer casing to header assembly, (1) screw from Step 4
and (1) screw supplied in hardware package.
Caution: Blower cord set routing is important. Cord set
should be in proper location to avoid being overheated. In-
correct routing of cord set may result in damage to cord set.
THE CENTER CLEARANCE
HOLE WILL NOT BE USED
Figure 9
23820-3-0409
Page 3